-
- Causes of cracking and bursting of stamping die formwork
2023-12-21 1
- The blanking is not smooth: when assembling the mold, there is no leakage, or rolling and blocking the shit, the foot is blocking the shit, which is the most common, and the assembly master is most likely to occur if he does not pay attention to it, like when the blanking hole is many, or when the mold has a pad.
-
- In the production and processing of metal stamping die, how to prevent waste jumping!
2023-12-21 1
- The waste moving up refers to the phenomenon that after the material is cut and separated in the punching process, the material remaining in the concave die is taken out with the rise of the punch, and then falls on the surface of the concave die.
-
- The most common problem of hardware mold repair
2023-12-21 1
- The most common repair problem of hardware mold should be burrs, some burrs are better to repair, and the gap can be fixed with a good knife edge, but some burrs are not just a gap problem.
-
- Metal die design problems and improvement methods
2023-12-21 1
- With the progress and development of society, metal molds are gradually widely used in various fields, and the design of metal molds is becoming more and more complicated. In view of the common problems in the design of metal die, this paper makes an in-depth study of the common problems, and analyzes the improvement methods for the corresponding problems. It has practical reference value to solve similar mold design problems.
-
- The prospect trend and design status of automobile stamping metal die
2023-12-21 1
- In recent years, the level of stamping die in China has been greatly improved. Large stamping die has been able to produce a single set of weight of more than 50 tons of die. For the mid-range car supporting the covering parts mold can also be produced in China. In the view of Luo Baihui, Secretary general of the International Mold Association, China's stamping die has been greatly developed in terms of quantity, or in terms of quality, technology and ability, but compared with the national economic needs and the world's advanced level, the gap is still very large, some large, sophisticated, complex, long-life high-grade molds are still imported every year, especially the cover parts of high-end cars. It is still mainly dependent on imports.
-
- Small cap drawing mold
2023-12-19 3
- A small cap drawing die is a tool used to make a small cap. A small cap is usually used to close the opening of a container or container to prevent the leakage of liquids or other substances. Such molds are usually made of metallic materials, such as steel or aluminum, to ensure their durability and stability.
