-
- Causes of cracking and bursting of stamping die formwork
2023-12-21 1
- The blanking is not smooth: when assembling the mold, there is no leakage, or rolling and blocking the shit, the foot is blocking the shit, which is the most common, and the assembly master is most likely to occur if he does not pay attention to it, like when the blanking hole is many, or when the mold has a pad.
-
- In the production and processing of metal stamping die, how to prevent waste jumping!
2023-12-21 1
- The waste moving up refers to the phenomenon that after the material is cut and separated in the punching process, the material remaining in the concave die is taken out with the rise of the punch, and then falls on the surface of the concave die.
-
- The most common problem of hardware mold repair
2023-12-21 1
- The most common repair problem of hardware mold should be burrs, some burrs are better to repair, and the gap can be fixed with a good knife edge, but some burrs are not just a gap problem.
